[Vespera range] How to set up the Light Pollution filter?

[Vespera range] How to set up the Light Pollution filter?

To avoid damaging or dirtying the filter, do not handle it by the glass.

  1. Turn on your Vespera.
  2. Connect to Vespera via the Singularity application.
  3. In the application, go to the "Space Center" page.
  4. Navigate to the "Instrument" section.
  5. Press "Open Arm". The arm will open 180°.


6. Remove the lens ring from the front of the optical arm by pressing the designated button.



7. Insert the light pollution filter

If installed correctly:

  • A filter icon and the name of the filter "CLS" will appear under the product image.
  • You can then initialize the product and start an observation.













If the installation is incorrect or faulty:
  • The filter icon will not appear under the product image, and the message "No filter detected" will be displayed.
  • Remove the filter, reinstall it carefully, and try again. If the issue persists, please contact support.

If the assembly is not in conformity or is faulty:
  1. The filter icon does not appear under the product image and the mention "no filter detected" is readable.
  2. Remove the filter and start the assembly again. If the problem persists, contact support