How to set up STELLINA on its Benro tripod?

How to set up STELLINA on its Benro tripod?


Depending on the date of your order and due to a change of supplier, the brand of your tripod may vary (Gitzo or Benro). Find below the steps to install your Benro tripod at the reception of your product.

 

ÉTAPE 1
Get the tripod and remove the plastic plug (opposite blue) on the thread of the flat base.

Lift the 3 sliding stops (with a B engraved on them) open the legs completely and set them on the second setting.

 

 

ÉTAPE 2
Use the locking lever to loosen the flat base. To do this, push in the black lever until it covers the screw, and turn it upwards. Release and repeat several times.

 

 

ÉTAPE 3
Click on the safety button on the side of the tripod and lift the flat base to remove it.

 

ÉTAPE 4
Screw the flat base to the foot of Stellina.

 

 

ÉTAPE 4a (optional)
To prevent the assembly from getting loose, it is recommended to screw the side screw with the Allen key supplied with the tripod.

 

ÉTAPE 5
Gently place Stellina on the tripod until you hear a click.

 

ÉTAPE 6
To secure the camera on the tripod, use the locking lever to tighten the flat base. To do so, push in the black lever until completely covering the screw, and turn it downward. Release and repeat several times.

 

ÉTAPE 7
Check the bubble level and screw or unscrew the telescope feet if necessary.